Real Estate Information Archive

Blog

Displaying blog entries 1-2 of 2

Consumer Protection from Irresponsible Mortgage Practices

by The Mike Parker Team

Congress enacted the Dodd-Frank Act in 2010 in response to the mortgage crisis that led to America's Great Recession.  The two parts that apply closely to homebuyers are the Ability-to-Repay (ATR) and Qualified Mortgages (QM).

A Qualified Mortgage is a category of loans that have certain, more stable features that help make it more likely that borrowers will be able to afford their loan.  These loans do not allow certain risky features like an interest-only period when no money is applied to reduce the principal; negative amortization that would allow the mortgage balance to increase; and, "balloon payments" at the end of the loan that are larger than the normal periodic payments.

A debt-to-income ratio of less than or equal to 43% has been established to provide a limit on how much of a borrower's income can go toward total debt including the mortgage and all other monthly debt payments.  However, the Consumer Finance Protection Bureau believes these loans should be evaluated on a case-by-case basis and in some cases, can exceed 43%.

There is a limit for up-front points and fees the lender can charge.

By showing that the lender made an effort to be certain that the borrower has the ability to repay the loan, the lender in turn, receives certain legal protections.  Underwriting factors considered by the lender include:

  1. current or reasonably expected income or assets 
  2. current employment status
  3. the monthly payment on the covered transaction 
  4. the monthly payment on any simultaneous loan 
  5. the monthly payment for mortgage-related obligations
  6. current debt obligations, alimony, and child support
  7. the monthly debt-to-income ratio or residual income
  8. credit history

For more information, see the Consumer Financial Protection Bureau fact sheet ... protecting consumers from irresponsible mortgage lending.

Quick Plumbing Inspection

by The Mike Parker Team

No one wants to waste water or money.  For that reason, take a few minutes every other month to do the following inspections:

  1. Check to see if cutoff valves on sinks and toilets are working properly. 

    Many times, builders will put individual cutoffs on supply lines to sinks and toilets.  It is reasonable to expect them to work but after some time, they can corrode which prevents opening and closing.  It is a good idea to test them occasionally before you need them in an emergency.

  2.  Fill each sink with a few inches of water to see if they drain in what you feel is a normal time.

    A slow-draining sink can be an indication of a clog that builds up around the insides of the pipe.  Common causes are food, grease, hair and soap scum.  Plunging can take care of some slow-running sinks.  After partially filling the sink with water, seal the plunger over the drain and pump it up and down a few times.

  3.   Inspect each toilet to see if they are leaking water from the tank into the bowl.

    Toilets that continue to run after being flushed can use a large amount of water in a month's time.  Generally, the problem comes from a flapper that doesn't seat properly.  Sometimes, the chain is keeping it from closing properly or the flapper itself may need to be replaced.

    Another issue could be that the flush valve needs to be replaced.  These can be purchased at Lowe's or Home Depot for about $20.00 and are relatively easy to change out.  There are lots of instructional videos on the internet and it can save money if you give it a try.

If you need a recommendation for a good plumber to take care of something you discover, please feel free to call me at (859) 486-3300.

Displaying blog entries 1-2 of 2

Syndication

Categories

Archives

Share This Page

Contact Information

Photo of Mike Parker - CRS Real Estate
Mike Parker - CRS
HUFF Realty
60 Cavalier Blvd.
Florence KY 41042
859-647-0700